from Flow Factor
The SRH (Steam Ring Heaters) are compact, inline jet pumps with low pressure drop. SRH units inject steam through a ring-shaped opening within an enlargement in the pipe line. Liquid passes through and around the ring. Heat is introduced by the direct condensation of the steam. The SRHs provide fast temperature correction noiselessly and without vibration if correctly applied. Because the liquid flow area is unrestricted, pressure drops across the SRH are minimized. This will reduce the horsepower requirements for the operating pump.
The Emerson Penberthy SRH injectors provide liquid flow rates up to 500 GPM. Temperature rises range up to 200 degrees F. Heat input ranges up to 128,000 BTU per minute at 150 PSIG operating steam pressure. The Steam Ring Heater jets can be installed in either series or parallel arrangements for increased capacities.
The SRH units come in the below sizes.
Model 310
Inlet is 1.5 inches, outlet is 1.5 inches and steam port is 1 inch.
Model 320
Inlet is 2 inches, outlet is 2 inches and steam port is 1.25 inches.
Model 330
Inlet is 3 inches, outlet is 3 inches and steam port is 1.50 inches.
Model 330F (Flanged)
Inlet is 3 inches, outlet is 3 inches and steam port is 1.50 inches.
216-765-4231
www.flowfactor.com
Cleveland Ohio USA
No comments:
Post a Comment