General Purpose Solenoid Valves Normally Closed
Type 1 two-way solenoid valves can be used on either low or high pressure. The smaller valves are direct acting while the larger valves are pilot operated.
Applications:
These valves are for general application on non-corrosive fluids such as air, water below 180°F, light oils below 300 SUS, and low vacuum. All seal off bubbletight.
Type 3 two-way solenoid valves have a brass body with a stainless steel seat insert and a teflon diaphragm.
Applications:
These valves are developed primarily for use on hot water and low pressure steam (to 10psi), but can be used on air and other non-corrosive fluids. They can be used with fluid temperatures ranging from -20° F to 240° F.
Type 4 two-way solenoid valves have a brass body with a stainless steel seat insert and an ethylene propylene (EPT) diaphragm and seals.
Applications:
These valves are recommended for steam service up to 50 psig saturated steam.
These valves uses the G23 coils.
PARKER GP23 coil, 24 VAC for Parker GP valves part number 77300
PARKER GP23 coil, 120 VAC for Parker GP valves part number 77310
PARKER GP23 coil, 240 VAC for Parker GP valves part number 77320
PARKER GP23 coil, 480 VAC for Parker GP valves part number 77340
PARKER GP23 coil, 120/240 VAC for Parker GP valves part number 77360
PARKER GP23 coil, 12 vdc for Parker GP valves part number 75520
PARKER GP23 coil, 24 vdc for Parker GP valves part number 75530
GP 200 is part number 70221
GP 207 is part number 70222
GP 257 is part number 70223
GP 300 is part number 70393
GP 307 is part number 70393
GP 357 is part number 70223
GP 400 is part number 70562
GP 407 is part number 70563
GP 457 is part number 70564
GP 600 is part number 70712
GP 607 is part number 70713
GP 657 is part number 70714
GP 10A is part number 70810
GP 1007 is part number 70808
GP 1057 is part number 70777
(The GP valve numbers are linked at the top of the page under their descriptions.)
www.flowfactor.com
866-360-9830
No comments:
Post a Comment